Push the base firmly into the vehicle seat while
pulling each LATCH harness tight (Fig. E).
Close lock-off plate over the LATCH harness,
then secure by closing both tabs while pressing
firmly on the lock-off plate (Fig. F).
Lock-off is properly secured when tabs are flat
against lock-off plate.
Check recline angle. If adjustment is necessary,
release tension on LATCH straps and adjust
angle, then re-tighten.
Verify that all connections are secure and the
base is stable. Base is stable when it moves less
than 1 inch front to back or side to side.
Base Removal:
Loosen the LATCH straps, then release each LATCH connector from
the LATCH anchor by pressing the release button on the LATCH
connector.
When not in use, always store the LATCH connectors on storage ring
at front of base.
9.
10.
•
11.
12.
•
If there is a problem achieving the proper recline
angle, collapse the recline adjuster and place a
rolled towel or pool noodle in the crease of the
vehicle seat to help level the base.
•
Base Installation
21
E
D
F
WARNING!
Only raise base as
described above. Do not raise the base
off of the front edge of vehicle seat; doing so will
reduce protection of your child.
