Instructions for Installation & Use
- Series number: 2030/A/2010
Instructions for Installation & Use
- Series number: 2030/A/2010
34
35
CARE AND MAINTENANCE
CARE AND MAINTENANCE
E.
Feed crotch buckle 3-bar slide through cover
and Carrier. Refer to page 19 for correct crotch
3-bar slide position for your baby and adjust if
necessary.
F. Refit plastic flap on trim to Carrier by rotating to fit
under the side moulding.
G.
Engage shoulder harness tongues and crotch
buckle and pull to check harness is attached.
H.
Ensure straps are not twisted.
IMPORTANT:
When replacing cover, ENSURE THAT ENGAGEMENT OF HARNESS STRAPS BY PULLING
FIRMLY.
CAUTION:
Do not use the Baby Safety Capsule with harness shoulder straps set at different heights or
fed through mis-matching slots.
Plastic
flap
Click
TO CLEAN HARNESS BUCKLE:
If sticky liquids such as baby formula, fruit juice, etc. get
inside your Harness Buckle, it may become sluggish. An
indication of a sluggish Harness Buckle is that you cannot
hear a click when engaging the Harness Tongues. To
restore the Harness Buckle to good working order it needs
to be cleaned as follows:
A.
From the underside of the restraint pull each crotch
3-bar slide then turn 3-bar slide and push through each
slot to remove the Harness Buckle from the restraint.
B.
Place the Harness Buckle under warm (max. 40
degrees Celsius) running water as shown below. Let
the water run through the mouth of the buckle for five
minutes.
C.
Engage and disengage the Harness Tongues and
Buckles several times until a strong audible click is
heard when inserting the last tongue.
D.
If you still cannot hear a strong audible click after
engaging the Harness Tongues and Buckle, then repeat
cleaning several times. If the Harness Buckle cannot be
returned to its original working condition then contact
Britax Childcare Customer Service.
E. Refit the harness buckle to the restraint with the red
button facing out and feeding each 3-bar slide through
appropriate slot (refer to page 19).
Cover
Body
3- bar
slide
A
B
C
