Instructions for Installation & Use
- Series number: 2030/A/2010
Instructions for Installation & Use
- Series number: 2030/A/2010
28
HOW TO USE
29
HOW TO USE
PLACING BABY & CARRIER IN BASE
A.
Position the Carrier over the top of the Base and
align the Carrier bosses with the Base hooks.
B.
Slide the Carrier bosses fully into the Base hooks
then lower the opposite end of the Carrier.
C.
Make sure the Harness Adjustment Strap is not
caught between Carrier and Base while lowering
Carrier into Base until the "PRESS" catch snaps into
place. Fold both handles down.
SNAP
C
B
D.
Ensure the boss retention caps completely
cover the Carrier bosses. Engage Upper
Anchorage Strap bracket to the upper
anchorage strap attachment clip. Ensure
that none of the straps are twisted or
catching on sharp edges.
E.
Adjust Upper Anchorage Strap by pulling
as shown to eliminate any slack in straps.
NOTE:
Seat belt extenders should not be
used if the seat belt is not long enough to
secure the child restraint. If they are used
then the buckle must not enter the seating
zone.
CAUTION:
THIS TETHER STRAP MUST ALWAYS BE
FITTED WHEN THE CHILD RESTRAINT IS
USED IN A VEHICLE.
Always attach hook and remove
slack.
Upper Anchorage
Strap Attachment Clip.
Upper Restraint
Strap Bracket.
Boss retention cap
:
Fully press Adjuster Button (A) while
pulling Upper Anchorage Strap (B) to
lengthen.
B
A
E
Boss
Hook
A
"Press"
