6
ENGLISH
First of all, remove your existing kitchen tap.
a) Turn off the cold and hot water supplies
b) Please make sure you release any pressure by opening all levers.
!
No water should run through the existing kitchen tap.
c) Unscrew the existing hoses from the cold and hot water supply.
!
We recommend placing a suitable container under the water
supply as there will be water left in the hoses which will run
down when you unscrew them.
d) Unscrew your kitchen tap – there is no standard mounting but
in general a pipe wrench will help you to unmount it.
e) Pull out both your kitchen tap and the hoses.
!
Make sure a suitable container is placed under the water
supply. Open the water supply to rinse the pipes thoroughly
before installing the new tap. Caution on the warm water
supply.
f) Put your 3-way filter tap in the 35 mm hole. Ensure the correct
order of the components. Check tap position and fix the screw
nut, then the 2 additional screws (fig. 5, no. 7+8).
Step 4: Install the filter system
Please follow the diagram below (see fig. 6) and perform the steps
in the right order.
!
If you do have an additional free 1/2" or 3/8" cold water
supply for the 3-way filter tap in your kitchen, you do not
need to install the supplied T-piece. If your water supply does
not fit the 3/8" connector, use the supplied adapter. Your
Installation Kit comes with two 1/2" adapters.
Connect the T-piece
Connect the supplied T-piece with the cold water angle valve.
Please make sure that pre-assembled gasket is right inside.
Attaching the hoses
All hoses have pre-installed gaskets. Please make sure that no
gasket is missing and that pre-assembled gasket is inside.
A) 3 hoses from the filter tap
-
Connect the hose with the red stripe with your hot water supply.
-
Connect the hose with the blue stripe to one side of the T-piece.
-
Connect the 1000 mm grey hose which is connected with the
filter tap with the outlet of the filter head labelled with an “OUT”
arrow.
Make sure that the gaskets are seated correctly!
B) Seperated hose delivered in the installation kit
-
Take the hose with two connectors. Connect one end with the
free side of the T-Piece.
-
Connect the other end with to the filter head inlet. This is
labelled “IN” (inlet) and marked with an arrow.
Make sure that the gaskets are seated correctly!
Make sure all connections are tightened properly. Avoid over tightening.
(fig. 6)
Hot water
supply
Cold water
supply
!
The max. tightening torque for the G 3/8" connections may
not exceed 14 Nm! Only hose connections with washers
may be used – hoses with conical screw connections dam-
age the connections of the filter head and invalidate any
warranty claims.
(Adapter 1/2" to 3/8",
only UK)