Operation & Temperature Setting
On/Off and Temperature Control
On/Off and Temperature Control
On/Off and Temperature Control
On/Off and Temperature Control
Turn the control (1) anti-clockwise to
turn on and increase the temperature.
Turn the control (1) clockwise to
decrease the temperature and turn off.
The maximum temperature is factory
set to 43ºC however this can be
adjusted to suit different site conditions
(see below to re-set maximum
temperature setting).
Maximum Temperature Setting
Maximum Temperature Setting
Maximum Temperature Setting
Maximum Temperature Setting
The maximum blend temperature
should be limited to ensure that no
undesirable temperature is obtained. If
adjustment is necessary the following
should be carried out:
1
OP TS1503 EH C
OP TS1503 EH C
OP TS1503 EH C
OP TS1503 EH C shown below
should be carried out:
•
Turn the control knob anti-clockwise
so the shower is running at full flow
and is at the maximum temperature
(allow the flow/temperature to stabilise
for a few minutes).
•
Remove the handle by prising out the
cap and removing the grub screw.
•
Slide a 2.5mm hexagonal key down
through the centre of the spindle and
turn the adjusting screw anti-clockwise
for a warmer temperature and
clockwise for a cooler temperature.
•
When the desired maximum
temperature is achieved replace the
control knob, tighten the grub screw
and push fit the cap back into the
handle.
18
Need help?
Need help?
Need help?
Need help? Give us a call on 0844 701 6273
0844 701 6273
0844 701 6273
0844 701 6273 and speak to one of our trained advisors.
