Turn on the water supplies to the Mixing
Valve and open the stop / service valves
to the mixing valve.
Check that there are no leaks around the
connections to the inlets and outlet.
Purge Procedure
After checking the water / plumbing
connections and before using the shower
as normal the Mixing Valve will need to be
purged. Please run through the following
procudure.
1.
Ensure both power and water supplies
to the Mixing Valve are on.
2.
Turn the Controller On by rotating the
lever to any of the flow positions. The
shower will run.
3.
Press and buttons
at the same
time
for 3 or more seconds then let go.
4.
‘0’ should be displayed. If not repeat
step 3.
5.
Press button once. ‘1’ should be
displayed.
6.
The purge sequence will now run.
(Short pulses of water output from the
shower for about 12 seconds).
7.
Once the pulsing stops, turn the
Controller Off.
8.
To resume normal showering, simply
turn the Controller on as normal.
46ºC
SW1-1 ON
SW1-2 ON
SW1-3 OFF
48ºC
SW1-1 OFF
SW1-2 OFF
SW1-3 ON
Once the switches have been altered,
to the desired position the maximum
temperature is set.
3.
Replace the Mixing Valve cover and
secure with the five fixing screws.
IMPORTANT:
It is important to power down the Mixing
Valve to change the switch settings as
they are only read on power up.
Checking Water / Plumbing
Connections
Before using the shower for the first time
the installer needs to check that the
water/plumbing connections are correct.
The cold water supply pipework should
only be connected to the inlet marked
COLD on the Mixing Valve cover.
The hot water supply pipework should
only be connected to the inlet marked
HOT on the Mixing Valve cover.
ON
1
2
3
4
ON
1
2
3
4
Need help?
Give us a call on
0330 026 6273
and speak to one of our trained advisors.
Commissioning
16