8
Slide the Contact Skin Frame into the guides in the top of the incubation chamber.
Note that the frame is not square and will only push in fully when fitted the correct
way round. The frame will be a tight, sliding fit to ensure a good air seal. The black
felt should be on the top.
Replace the drawer by aligning the slides and pushing back in. The catches will
automatically engage to prevent accidental release.
5.4
Forced Draft Mode
Remove the drawer by sliding fully forward and releasing the spring catches on the
drawer slides. Note that the catches operate in opposite directions.
Place the Base Insulation Panel in the bottom of the incubation chamber and ensure it
fully covers all the large holes.
Place two layers of Evaporating Material into the recess in the top of the panel and lay
the water tube over the top of the material with its end near the centre.
Summary of Contents for CONTAQ Z6
Page 1: ...1 Operating Instructions ...
Page 27: ...27 ...
