7
5.2
Humidity Sensor
IMPORTANT:- For correct operation the humidity sensor must be fitted as shown.
Remove the drawer by sliding fully forward and releasing the spring catches on the
drawer slides. Note that the catches operate in opposite directions.
Plug the humidity sensor into its socket in the right hand wall of the egg chamber.
Ensure the sensor is the correct way up and pushed fully home into the socket. The
label “ETC” should be face down.
5.3
Contact Mode
Remove the drawer by sliding fully forward and releasing the spring catches on the
drawer slides. Note that the catches operate in opposite directions.
Place layers of Evaporating Material flat in the base of the incubation chamber. Two
layers may be required to achieve higher humidity levels, cover the large holes with
the material. Lay the water tube over the top of the material with its end near the
centre.
Summary of Contents for CONTAQ Z6
Page 1: ...1 Operating Instructions ...
Page 27: ...27 ...
