1
4 3/4”
121mm
6
1/
2
“
170
mm
CS010 US Issue 01
Installa
�
on and
Opera
�
ng Instruc
�
ons
Important! Install the ChickSafe Eco and a
�
ach the door BEFORE installing ba
�
eries.
Failure to observe this may cause incorrect opera
�
on and possible damage.
(See page 3).
The ChickSafe is supplied pre-set to be a
�
ached to a FULLY OPEN DOOR. Failure to
observe this will cause incorrect opera
�
on and possible damage.
(See page 3).
Please read these instruc
�
ons carefully before se
�
ng up your ChickSafe Eco to achieve best results and keep these
instruc
�
ons safe for future reference.
To register your new Brinsea product and qualify for your free 3 year warranty please visit www.brinsea.com within
30 days of purchase and follow the link on the Brinsea home page. The serial number may be found on the box
and inside the ba
�
ery compartment. Sign up for the Brinsea newsle
�e
r to receive the latest news and informa
�
on.
Warning - Risk of injury! Keep fingers clear of moving door and cord. Motor may start without warning.
Ensure the maximum door weight of 8lbs (4kg) is not exceeded as this will cause damage to the motor
and invalidate the warranty! Note that wooden doors are heavier when wet.
The maximum door lifting height is 15” (400mm). Do not exceed this as operation will be incorrect and
the cord may become detached.
Check the sliding door to make sure it runs smoothly and reliably both upwards and downwards. The
ChickSafe uses gravity alone to close the door.
To mount the ChickSafe further away from the door, an additional length of cord may be attached. For
helpful information see our ChickSafe ‘Frequently Asked Questions’ page at www.brinsea.com
This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children
without supervision.
Tools needed for installa
�
on:
-
Screwdriver (cross head PZ1)
-
Drill with a 1/8” (3mm) diameter
drill bit, or bradawl
-
Tape measure
Cau
�
on! - Please Note:
•
Use only alkaline AA ba
�e
ries
•
Observe correct polarity to
prevent leakage or risk of
fi
re
•
Do not mix old and new
ba
�e
ries
•
Do not use re-chargeable
ba
�e
ries
•
Do not use a 9 volt ba
�e
ry
•
Remove the ba
�e
ries if you do
not intend to use the ChickSafe
Eco for a long period.
1
Raise the sliding door to its fully
open posi
�
on.
Support the door in that
posi
�
on.
Once
fi�e
d, the ChickSafe will
always open the door to this
height. Make sure it is correct.
2
1/8” (3mm)
Mark two hole posi
�
ons 4 ¾”
(121mm) apart and approximately
6 ½” (170mm) above the top of the
sliding door.
Make sure they are level and evenly
spaced above the centre of the door.
Make the holes with a 1/8” (3.0mm)
drill bit or bradawl.
•
•
•
•
•
•
•
•
