13
L-1762-L
English Manual
================================================================================================
ASSEMBLY
: 40” Plug Aerator (
PA-403BH
)
STEP 8
- - - - - - - - - - - - - - - - - - - - - - - - - - - -
22
25
16
25
11
30
23
30
10
22
Combine:
- x1 Hex
Bolt (
22
) - 5/8” x 4”
- x1 Flat Washer (
25
) - 5/8”
Slide the bolt assembly through one
wheel (
16
) (wheel hub pointing toward
the threads of the bolt) and add:
- x1 Flat Washer (
25
) - 5/8”
- x1 Hex Nut (
30
) - 5/8”
Thread the hex nut as far as possible,
still allowing wheel to rotate freely.
continue by running the hex bolt
through holes in Lift Handle (
11
)
(and
Axle Assembly (
10
) on the other end of
the Aerator).
Secure with:
- x1 Lock Washer (
23
)
- x1 Hex Nut (
30
)
Tighten the inside Hex Nut while holding
the Hex Nut next to wheel stationary.
IMPORTANT:
The wheel hubs are offset to one side.
Make sure the extended offsets are installed toward plug aerator.
STEP 9
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
27
32
11
Insert Transport Pin (
27
) in rear hole
same side as the Lift Handle Assembly
(
11
) as shown. Secure with Nylon Lock
Nut (
32
).
NOTE - Moving the wheels
in and out of transport mode:
Lift handle assembly (11) will pivot and
raise / lower the wheels. This transport
pin (27) allows the handle to be locked in
place during transport.
