Brillion TURFMAKER Junior SLP2041, Operator'S Manual

Page: 16 / 42

1P128
To increase the rate of seeding, loosen the nut on inside of
the bearing and turn the outer nut to move the seed shaft to
the desired higher number setting, then re-tighten the
inner nut.
To decrease the rate of seeding, loosen the outer nut
and turn the inner nut to move the seed shaft to the
desired lower number position; then re-tighten the
outer nut.
Seed cups discharge to the front of the
machine to aid the tractor driver in
determining proper operation.
Seed Rate Adjustment
Note: Wrenches for adjustment are stored on a rivet on the right-side end plate. (See Figure11)
IMPORTANT: To prevent damage to seed meters, do not apply excessive force to adjusting
nuts. This is especially important when closing meters as seed in flutes can be
pinched between cut -off and washer in seed cup. Do not attempt to open meters
more than 1”. (Feed rolls could become disengaged from washer in seed cup.)
Seed rate is set by adjusting the micro-meter on the right side of the machine.
Note: Before you begin, be sure pointer
reads “0” when cups are complety closed .
Increase:
shaft moves this direction
Decrease:
shaft moves this direction
VIEW FROM
FRONT
FRONT OF
MACHINE
Adjust pointer
position here.
OUTER
ADJUSTING
NUT
INNER
ADJUSTING
NUT
POINTER
Operating Instructions/ Seeding Rate
806 Page 14