Brillion HFC Series, Assembly Instructions Manual

Page: 29 / 64

BEARING (Grease
inside surface.)
4K241-LEFT WING
AXLE ASSEMBLY
LOCKNUT,
1”
BEARING
(Grease inside surface.)
CYLINDER 2K094
(Ports Face Rear)
4K302--RIGHT HAND
SCREW ANCHOR (use
on LEFT wing)
FRONT (L.H.)
WING HALF
FIGURE 19
BOLT
3/4” X 14”
23 7/16”
NOTE:
REAR (L.H.)
WING HALF
L.H. AXLE - 23 7/16”
R.H. AXLE - 18 9/16”
MOUNT THE WING GAGE WHEELS TO EACH WING
Do not tighten any hardware until told to do so.
1.
If not already mounted, mount (4) 9.5L-15 6-Ply tires to 8” wide rims, then attach them to the walk
ing beams of each wing rockshaft assembly. (This step is not shown in the drawing below. See
center rockshaft drawing if needed.)
2. Place a cast iron bearing half over each of the two pairs of holes near the outside rear of each wing.
Temporarily hold the bearings in place by inserting a 3/4” x 14” long bolt through each of the bearing
holes and extending it through the holes in the wing frame tubes. Apply a generous layer of grease
to the inside of these bearing halves. Lower the wheel and axle assembly onto the bearing halves.
The left and right wing rockshafts are identified by the dimensions shown in the drawing. 4K241
is the left axle assembly and 4K242 is the right axle assembly.
Make sure that the wheel arms are facing forward and the cylinder arms are above the rear frame tube
as shown. The two bearing stops on the axle pipe will be inside from the bearings.
3. Remove the bolts from the bearing halves. Apply a generous film of grease to four more bearing
halves and place these over the bearings already in place. Re-insert the 3/4” x 14” long bolts
through the bearings and frame tubes and attach the 3/4” locknuts.
These locknuts should now be tightened securely to the bolts. Apply 125-160 ft-lb torque to the nuts.
23 7/16”
BOLT 1” x 9 1/2”
5K094 799
rev3-23-05
Page 26