Pa
g
e
1
4
ASSEMBLY INSTRUCTIONS
Additional parts identification and location can
be obtained from reviewing parts catalog.
To assemble machine, select a smooth level
area that can be reached by a hoist or lift truck.
NOTE:
6-shank frame unit is shown in figures.
The smaller and larger frame units
are similar but reference to figures may not
always be an exact representation.
STAND
STAND
MOUNT
CLEVIS PIN, 3/4” x 4”
HAIRPIN COTTER
HHCS, 5/8-11NC x 1-3/4”
LOCK NUT, 5/8-11 NC
COTTER PIN,
3/16” x 3”
FRAME
Figure 6
NOTE:
Supports not shown. Stands
may not be shown in following
figures in order to make other
parts more identifiable.
Note: Mount stands as far toward
the outsides of the machine
as
possible.
Basic Machine
1.
Place frame on supports (approx. 38”
high). Be sure supports will hold 1500#
each.
DO NOT WORK UNDER
MACHINE UNLESS IT IS
BLOCKED UP SECURELY.
2.
If your model has frame extensions,
mount them to the frame ends with 5/8”
capscrewss and lock nuts, and mount the
stand mounts to the front of frame with
3/4” U-bolts, lock washers, and nuts. See
Figure 6. Install the stand into the stand
mount and fasten with 3/4” dia. x 4” clevis
pin and hairpin cotter.
A
ssemblyy
Assembly
STAND
NUT, 3/4-10NC
LOCK WASHER, 3/4”
U-BOLT, 3/4”
FRAME EXTENSION
9K308
604
Page 12
Summary of Contents for Compaction Commander 03 Series
