Brill MulchCut 36 ES, Manual

Page: 20 / 41

18
GB
Malfunction Possible Cause Remedy
Abnormal noises, clattering in Loose screws on the motor, its Tighten all screws.
the machine. fixing pieces or the mower housing.
Unsteady running, strong Damage to the cutter bar or cutter Tighten the cutter and cutter bar
vibration of the machine. (unbalanced running), cutter bar fixture screws.
holder on the motor drive shaft Have damaged parts replaced by
loose. the Brill service centre .
Mower leaves deep furrows. Ground soaks through, Allow lawn to dry, do not use
lawn too wet. mower on wet grass.
The grass is tawny. Cutter too blunt. Change and/or turn cutter,
Irregular cut. Cutting height set too low. respectively.
Set the cutting height a little higher.
General
Malfunctioning mostly only occurs
when the machine is not treated
properly, maintained or serviced.
The following table includes the
most likely malfunctions to occur
and their remedying.
In cases of further disruptions,
please contact your nearest Brill
Service Centre or the specialist
dealer authorised by Brill.
A
Caution ! Repairs that re-
quire technical knowledge
should only be carried out by an
authorised specialist dealer.
A
Caution ! For safety reasons,
only original Brill spare
parts are to be used or those ap-
proved by Brill.
We would draw attention to the
fact that, under the product liability
legislation, we are not liable for
loss or damage caused by our
products when such are caused by
improper repairs or when during
an exchange of parts such parts are
used which are not manufactured
by or approved by ourselves, and
the repairs are not carried out by
an authorised Brill service
centre
or an authorised specialist dealer.
The same restrictions also apply for
supplementary and accessory parts.
7. Remedies for malfunctioning (Trouble-shooting)