5
2” adapter
Automatic
fl ow
controller
The hose led
through
the opening of
the skimmer
Connect
the hose
to this
end
Top part of the skimmer
Picture 8
1. Turn the pool pump off.
2. Close the main plug and all other tap-hole pipes
except the pipe from skimmer to which the vacuum
pool cleaner will be
fi
tted.
3. Pull the skimmer basket off.
4. Press the 2” adapter into the connector in the bottom
part of the skimmer, see picture 8.
5. Press the automatic
fl
ow controller into the 2”
adapter. The end of the controller indicating
„Connect To the hose to this end”
must point upwards.
6. Place the vacuum pool cleaner in the pool and leave
it to go down. Insert the hose down until it contains water and no air.
7. Lace the end of the hose through the mouth of the skimmer and connect the hose directly to
the automatic
fl
ow controller.
EN
3. Settings
After completing the installationm activate the pool pump. Let the pump run for several minutes in order
to to empty the air from the system. The vacuum pool cleaner should proceed the speed of 240-360 cm
per minute. In this moment, check the following settings of the vacuum pool cleaner.
Lenght of the hose
IMPORTANT:
While checking the lenght of the hose, the pump must be activated. When the pump
is running, the hose is shortened, while the pump is switched off, the hose is getting longer. While
the vacuum pool cleaner is running, place it the furthest possible from the connection point. (You can
move the vacuum pool cleaner easily in the pool by means of the bar and the brush.) The hose of the
vacuum pool cleaner should be suf
fi
ciently long to reach the end of the pool, plus one additional piece of
the hose. If necessary, remove super
fl
uous components from the middle part of the hose. By removing
the components from the middle part of the hose, you avoid the necessity of removing weights. Store
the extra components in case of possible exchange.
NOTE: While adding or removing the components of the hose, turn off the pump of the pool.
Adjustment of the hose
For the appropriate setting of the weight of the hose,
turn off the pump
and watch the vacuum pool
cleaner. The load of the hose is correct at that time when the disc remains straight at the bottom of the pool
and immersed pipes contain the angle of 45° with the
fl
oor, see picture 9. For the best way of cleaning,
the hose must not be pulled nor lifted by the vacuum pool cleaner. Move the weight on the hose after one
thumb, until you reach the correct load. In pools with a different depth, set
fi
rstly the hose in the deep part
and then move it towards the shallow part.
