4
Wet slightly both ends in the pool and stick them together by
turning. See picture 5. Repeat the process until you put together
the amount of components required. When you stick the weight
into the hose, according the instruction in the Table A, connect
the hose to the vacuum pool cleaner. See picture 6.
One component has two „socket” endings and the hose protector. This component should be
assembled last and should be installed to the vacuum pool cleaner connection.
Assembled vacuum pool cleaner should look like as follows:
Ending „socket” beside components „plug”/„drawer”
NOTE: The lenght of the hose in the picture
is not life size. You will need more
components than is shown in the picture.
The weight on the hose
Component „drawer”/„drawer”
10-30 cm
182 cm
305 cm
Picture 6
Ending „socket”
Ending „plug”
Picture 5
EN
2. Installation
The vacuum pool cleaner is assessed for the use in many different kinds of pools, consequently it compounds
a wide rank of different components (e.g. 2” adapter and the valve-cover for automatic
fl
ow controller).
Your need of these components depend on concrete parameters of your pool.
This guide describes the standard installation to the skimmer and appropriate installation to the hypotonic pipeline.
Read up both situations to
fi
nd out the most suitable solution for your pool and follow the instructions.
Standard installation
Pools with one skimmer through the use of automatic
fl
ow
controller. The advantage of this installation is the automatic
fl
ow controller automatically balances the
fl
ow between
the skimmer and the vacuum pool cleaner. We strongly
recommend to use the automatic
fl
ow controller to ensure
maximum safety and effort of the vacuum pool cleaner. The
valve automatically reacts to the changes of the
fl
ow by
which means ensures changes in the effort of the vacuum
pool cleaner necessary for providing required detergent
effect.
To fi t the hose to this ending
Automatic fl ow
controller
2” adapter
Insert into
the bottom of the skimmer
Picture 7
