19
Balancer Cube
Operator’s manual
2. Select the plane balancing acquisition mode by pressing [P2]
until the writing
ACq
is viewed
on the left display as shown in figure F3.10. When the machine is switched on, the acquisition mode
is set by default ;
Fig. F3.10 - “Balancing planes acquisition enabled” message
3.
Extract the Distance/Diameter sensor and place it on the rim that corresponds to the internal
planechosen to apply the balancing weight. See figure F3.7 for the ALS1 Program Type and figure
F3.8 for the ALS2 Program Type;
4.
Keep the sensor in the rest position until you hear the acquisition beep. If the sensor is left in the rest
position
after the beep
, further acquisition probing of that plane will be run without entailing
consequences;
5.
Set the Distance/Diameter sensor in the rest position immediately. If you hesitate with this operation,
the machine may detect an incorrect plane: in this case, restore the sensor in rest position and repeat
acquisition procedure;
6.
Extract the Distance/Diameter sensor and place it on the rim corresponding to the external
planechosen to apply the balancing weight. See figure F
3.9;
7.
Keep the sensor in the rest position until you hear the acquisition beep. If the sensor is left in the rest
positionfor a longer time, further acquisition probing of that plane will be run without entailing
consequences;
8.
Set the Distance/Diameter sensor in the rest position immediately. If you hesitate with this operation,
the machine may detect an incorrect plane: in this case, restore the sensor in the rest position and
repeat acquisition procedure;
3.3.5.2 Balancing
start
Once the selections/settings have been entered, you can run a balance by rotating manually the wheel
in clokwise direction until you hear a beep.
3.3.5.3 Search of the balancing planes
The purpose of the balancing planes search is to find the planes previously chosen by the operator in
order to apply the balancing weights. Proceed as follows:
1. Select the balancing planes search mode by pressing [P2]
until the writing SrC is viewed
on the left display as shown in figure F3.11.
Fig. F3.11 - “Balancing planes search enabled” message
Summary of Contents for OSPREY BP63
Page 1: ...BP63 OSPREY...
