13
machine can also automatically start by the
program setup.
DISPLAY UNBALANCE VALUE
When the spin ends, the display will display the
inner
and outer
unbalance value of the rim. Use your hand to pull
the wheel. When all the positioning lamps light
inside and outside light, the weight adding
position will be indicated.
Rotate the wheel, when the left side positioning
lamp all light, at this moment, the highest position
is the inner unbalance position and when the right
side positioning lamp all light, at this moment, the
highest position is the outer unbalance position.
Add the corresponding weight at the unbalance
point and start test again until the balance of the
tire.
1.
When start the machine, use hand to pull the
wheel to help it start rotation, especially to the
relative
bigger tire, to prolong the working life of the
motor.
2.
Check if there are any mistakes on the
dimension.
3.
Check if the balance methods meet the
configuration of the rim and select the balancer
most easily to balance.
4.
Check if the contract nut tight or not.
5.
When the balance ends, remove the tire. Pay
attention to handle it with gentle and avoid
knocking the main shaft. When clipping the
weight. Use the hammer to clip the weight on the
rim without too much force. Do not knock the
main shaft hardly to avoid damaging the sensor.
The position to add the weight should be free
from the grease and should be dry.
RESIDUAL UNBALANCE
VALUE DISPLAY
The minimum value of the standard weight is 5g
so if the weight you use is less than 5 g, the
wheel balancer will not display the value and only
displays the state of ―00‖. When you need to
display the residual unbalance value, you should
press
and the display will immediately
display the inside or outside unbalance value of
less than 5g. The maximum residual unbalance
value is 4 g.
BALANCE MODE SELECT
Select the balance mode according to the weight
adding position and the balance mode. Press the
mode switching key
to select the balance
mode. When you switch on the machine the
machine will automatic enter into the dynamic
balance mode and no need to select.
Balance mode introduction
ALU1
Dis1=Dis+
¾
’’
Dis2=Dis+Br
－
¾
’’
D1=D
－
1‖
D2=D
－
1‖
ALU1
－
to balance the aluminum alloy rim by
applying the weight on the 2 shoulders of the
rim.
3
/
4
”
”
3
/
4
”
1
/
2
”
Summary of Contents for CB460 Series
Page 1: ...I WHEEL BALANCER USER MANUAL Pls read this manual before operation ...
Page 14: ...11 Press to the option select item Enter the self calibration see the following FIG 9 ...
Page 27: ...24 ATTACHMENT Ⅱ Single phase power board cable diagram ...
Page 28: ...25 ATTACHMENT Ⅲ Electrical theory diagram Input ...
