Not for
Reproduction
6
Install the Roll Bar Safety Decals (Export
Models Only)
1. Remove the black and yellow CE safety decals (A, & B,
Figure 9) from the publications packet.
9
2. Remove the three (3) existing English language decals
(C) from the roll bar.
3. Refer to Figure 9 for decal installation locations. The long
decal, part number 5100536 (A) is installed below the
roll bar pivot of the roll bar. The short decal, part number
5100537 (B), is installed above the roll bar pivot.
Check the Engine Oil Level (Engines
with Remote Oil Tank)
Some models in this series of mower feature a remote oil tank
(A, Figure 10) that supplies oil to the engine.
10
1. Clean the area around the engine oil dipstick (A, Figure
11) and oil fill cover (B) to remove any debris.
11
2. Use the dipstick to check the engine oil level. Maximum
oil level is the “FULL” line (C) on the dipstick. If the oil
level is at the “ADD 1 QT.” line (D) or below, more oil
must be added.
3. If necessary, open the oil fill cover and slowly add
15W-50 synthetic oil. (See the engine oil operator’s
manual for other oil recommendations.) The remote oil
tank is designed to hold 5 qt (4,73 L) of engine oil.
4. Wipe the engine oil dipstick with a clean cloth and then
install it into the tank by pressing down firmly with your
hand. The engine oil dipstick has a detent (E) and it must
snap into place on the lip (F) of the tank housing so that
the dipstick is fully installed into the tank. This action
requires moderate force.
5. Close the oil fill cover.
6. If desired, a new self-locking tie can be installed to keep
the oil fill cover securely closed.
Check the Engine Oil Level (All Other
Engine Options)
Some models in this series of mower feature a Kawasaki
FX1000V engine (A, Figure 12). Refer to Figure 12 for the
location of components used in this procedure.
12
