Briggs & Stratton 71013, Installation & Operator'S Manual

Page: 12 / 44

10 BRIGGSandSTRATTON.COM
Maintenance
The power management system is designed to be
maintenance free under normal usage. However, inspection
and maintenance checks should be made on a regular basis.
Maintenance will consist mainly of keeping the power
management system clean.
Visual inspections should be done at least once a month.
Access to power management system must not be
obstructed. Keep 3 feet (92 cm) clearance around power
management system. Check for an accumulation of dirt,
moisture and/or corrosion on and around the enclosure,
loose parts/hardware, cracks and/or discoloration to
insulation, and damaged or discolored components.
Exercise the power management system at least once every
three months as described in the previous section
Testing
the Power Management System unless a power outage
occurs and Home Generator System has gone through
automatic sequence. Allow generator to run for at least
30 minutes.
Contact a licensed electrical professional to inspect and clean
the inside of your power management system at least once a
year.
When Calling the Factory
Before contacting Briggs & Stratton regarding service or
repair of this power management system, obtain the Model
Number and Serial Number from the unit data decal located
on or inside the enclosure.
To contact Briggs & Stratton call
(800) 743-4115
, between
8:00 AM and 5:00 PM CT.
Specifications
Rated AC Voltage . . . . . . . . . . . . . . . . . . . . . . .125/250 Volts
Frequency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .50/60 Hz
Relay Contacts
Rating . . . . . . . . . .125 VAC, 20A, 1 HP, 768 VA Pilot Duty
Dimensions . . . . . .Approximately 16” H X 12” W X 6” Deep
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .34 lbs.