18
BRIGGSandSTRATTON.COM
4. Pull wires up through rear bearing carrier (
A
, Figure
15). Set rear bearing carrier on rotor bearing and
stator. Verify second roll pin slot (
B
) in stator lines up
with roll pin (
C
) in rear bearing carrier.
5. Using a plastic, dead blow hammer, tap rear bearing
carrier evenly over rotor bearing and stator until it
seats.
NOTICE:
Do not use stator bolts to draw assembly together.
Figure 15
9. Once wires are connect, rotate brush set three times to
reduce the slack in the wires (
A
, Figure 17).
6. Insert stator bolts into each hole around the rear
bearing carrier. Tighten bolts in a criss-cross pattern
until snug, then torque to values listed in
Generator
Specifications.
7. Rotate engine flywheel by hand slowly to ensure that
the alternator is not binding.
8. Hold brush set with brushes down and tab
(
A
, Figure 16) facing you. Attach red #6 wire to negative
terminal (
B
) on the left. Attach blue #2 wire to positive
terminal (
C
) on the right.
10. Set brushes down into slot on rear bearing carrier
with tab facing down. Align holes in brush set and rear
bearing carrier and insert screws (
B
). Torque screws to
values listed in
Generator Specifications
.
11. Route wires away from all rotating parts, then install
cover.
Figure 17
A
B
Figure 16
A
B
C
Summary of Contents for 030430
