Brigantia 240DVRS25N, User Manual

Page: 12 / 43

24-DVRS25N
12
Installation Instructions
Outside wall installation example
The Brigantia 24-DVRS25N requires 120v for the operating system. There is a factory installed electrical
box to accommodate the connections. (see wiring diagram pg. 36)
The fireplace comes complete with a battery back-up system that will operate the fireplace for a limited
time in the event of a power outage.
The 120v circuit must be electrically grounded in accordance with the local codes or, in absence of local
codes, with the National Electrical Code ANSI/NFPA 70, or the Canadian Electrical Code CSA C22.1.
Electrical Requirements
Secure sidewall termination to fireplace
with Milpac
(DO NOT use silicone ) on
both inner exhaust and outer supply air
pipes. Once installed on the unit se-
cure the termination to the wall with
screws to each corner.
Horizontal termination 999-DV-HTCL is to be used for direct connection to the unit. If extending
the vent using flex, a change to the 999-DV-HTC is required.