Breville RM-BBL600XL, Instruction Booklet

Page: 7 / 11

Care and cleaning
13
Cleaning the motor base
• Wipe the motor base with a soft, damp cloth then
dry thoroughly.
• Wipe any excess food particles from the
power cord.
Do not use abrasive souring pads or cleaners
when cleaning the motor base as they may
scratch the surface.
Note
Cleaning the blender pitcher, lid, inner
lid and blade assembly
• Wash all parts in warm soapy water with a soft
cloth. Use a brush to dislodge stubborn foods.
Rinse and dry thoroughly.
• The blender jug can be washed on a normal cycle
in the dishwasher. Please place the blender jug
upside down. If not placed upside down, the dish
washer heating element may damage the jug base.
Periodically, run a cycle with the jar filled 1 ⁄
3
with
warm soapy water to help clean in between the
gaskets/washers of the blade assembly as fruit
juices can get in and act somewhat like an
adhesive which would make the blades difficult
to turn and therefore put extra pressure and
resistance on the motor.
Note
Removing stubborn or strong food stains
Strong smelling foods such as garlic, fish and some
vegetables such as carrots may leave an odor or
stain on the blender pitcher and lid. To remove, soak
blender pitcher and lid for 5 minutes in warm soapy
water. Then wash with a mild detergent and warm
water, rinse well and dry thoroughly.
Storage
Store your Breville ikon Hemisphere
TM
LCD Blender
upright with the blender pitcher, lid and inner lid
assembled and inserted on the motor base or beside
it. Do not place anything on top.
Reassembling your blender jug after
cleaning
Step 1.
Make sure all parts are clean and completely dry.
Step 2.
12
BE CAREFUL WHEN HANDLING THE BLENDING BLADES AS THEY ARE SHARP.
MISHANDLING OF THE BLADES MAY CAUSE INJURY.
and odors
To reassemble the blender - ensure the lower part of
the Blade Holder is clipped into place by aligning the
parts and squeezing together at the edges until they
snap together, and then replace the silicon seal onto
the blade assembly with the raised rim of the
Removable Silicone Gasket facing downward. Place
the Gasket onto the Blade Assembly and push down
until it clicks into place. You should be able to read
THIS WAY UP on the gasket. (see Fig 1).
You will notice 2 notches on the blade assembly
(see pg 11- Fig 1). Place these notches into the 2
slots on the bottom of the jug (see Fig 2). Twist
the Blade Removal System counterclockwise in the
direction of the indicator symbol until firmly locked
into position.
Operating your Breville ikon
Hemisphere
TM
LCD Blender
continued
Seal must be fitted firm around the blade holder.
Note
Fig 1
Fig 2