Breville Kinetix Aero BBL420, Instruction Booklet

Page: 13 / 32

12
OPERATING yOUR BREvILLE KINETIx
®
AERO
5.
Plug the power cord into a 230/240V
power outlet and switch on.
6.
Ensure the blender is in the
OFF position.
NOTE
Do not fill the blender jug above
the MAX line. When the blender jug
is filled at or near the MAX line place
one hand on the blender lid
to avoid displacement of the lid
during operation.
Select the required speed (1 to 12)
by turning the dial to the
corresponding speed.
Operate the blender only for the
appropriate amount of time required –
do not over blend.
7.
PULSE/ICE CRUSH button - For
ingredients that require short bursts
of power, like crushing ice. The
pulse feature can be used while the
blender is in the STANDBY position.
When pressed, the pulse button will
illuminate and will continue to operate
until it is released.
NOTE
The maximum amount of ice cubes
the blender can blend at any one time
is 1 standard ice tray or 250g.
NOTE
Use the PULSE button when the
food that is being processed is too
thick or coarse to circulate within the
blender jug.
8.
At the end of use, always ensure the
blender is turned to the OFF position.
Then switch the appliance off at the
power outlet and unplug the cord.
Ensure the motor and blades have
completely stopped before attempting to
move the appliance, or when the blender
is not in use and before disassembling,
cleaning and storing.
NOTE
During the blending process,
ingredients may stick to the side of the
blender jug. To push the food back onto
the blades, turn the blender to the OFF
position, switch off at the power outlet
and remove the power cord.
Remove the lid and use a plastic
spatula to scrape down the sides
of the jug. Replace the lid before
recommencing blending.
NOTE
If any moisture or liquid appears
on top of the motor base during
blending, turn the blender to the
OFF position, switch off at the power
outlet and remove the power plug.
Remove the blender jug. Wipe the
motor base immediately with a dry
cloth or paper towel to absorb the
liquid. Check the blade assembly is
correctly assembled.