Breville BIR300, Instruction Booklet

Page: 12 / 20

12
!
NEVER LEAVE THE IRON
UNATTENDED WHILE IT IS
CONNECTED TO AN
ELECTRICAL OUTLET. SPECIAL
CARE SHOULD ALWAYS BE
TAKEN WHEN THERE ARE
CHILDREN IN THE VICINITY.
FILLING THE WATER TANK
Step 1.
Always ensure that the iron is
disconnected from the power outlet before
filling with water.
Step 2.
Set the Steam Selector dial to the
dRY position.
Step 3.
Open the Water Filling Cap and with the
iron held at an angle, slowly pour water
from the water filling beaker provided into
the filling inlet until the maximum water
level is reached. do not fill the water tank
beyond the maximum water level line. do
not use vinegar, starch or other chemically
descaled water.
Step 4.
Push the Water Filling Cap down firmly
to close.
NOTE:
During the ironing process, always
ensure that there is sufficient water
in the water tank.
OPERATING YOUR BREVILLE JETSTEAM IRON
OPERATING THE
STEAM SETTINGS
Steam ironing is only possible at higher
ironing temperatures, as per the indications
on the temperature dial (cotton to linen).
Step 1.
Plug the power cord into a 230V or 240V
power outlet and turn the power on.
Step 2.
Set the Temperature dial to the required
position within the steam area and wait until
the heating Indicator Light goes out.
Step 3.
Set the Steam Selector dial to the required
setting ie. From minimum to maximum
steam. The iron is now ready for use.
NOTE:
Always ensure that the Steam
Selector Dial (located in front of the
Temperature Dial of the iron) is set to
correspond with the setting on the
Temperature Dial. If you attempt to
iron with the Steam Selector Dial set
to maximum and the Temperature
Dial simultaneously set to a relatively
low ironing temperature, the
water will not be able to vaporise
completely, resulting in water leaking
from the soleplate.