11
ATTENTION!
Make sure that the power switch is at the OFF position.
Using the handle open the battery compartment and pull
it out.
Insert fully charged batteries into the compartment
according to the polarity shown in the battery slots.
Always insert two batteries with the same polarity in each
slot.
The following batteries with 1.5V output can be used:
1. High-density alkaline batteries (recommended) or
Lithium ion batteries
2. Rechargeable alkaline batteries
3. Rechargeable NiMH batteries
There are 4 battery slots.
*not included with your purchase
Two slots are combined to one group. The slots of the
two groups are marked with “1” and “2”. For normal
power supply only one group is needed but however it is
recommended to insert batteries in all the slots.
When the batteries are low the camera automatically
shuts down after two indication sounds. Please change
the batteries in time. Remove used batteries from the
device immediately! If the MMS function is activated, you
will be informed about low-battery-status.
3.2 Inserting the SD-card* and SIM-card*
Open the bottom cover. Insert the SD-card* into the card
slot with the unmarked side facing upwards. Please note
that the card can only be inserted in one direction. Make
sure that the write-protect switch of the SD-card is in
the “write” position as otherwise the camera cannot be
switched on.
GB
