EN
19
Wireless Smoke and Heat Alarm 868.3 MHz
CAUTION! DANGER OF ELECTRIC SHOCK!
Make sure that
you do not damage electrical cables in the wall during installation.
The device is equipped with an installation plate which allows it
to be installed on a wall or ceiling. The enclosed fastening
materials are suitable for concrete surfaces. For other substrates,
appropriate fastening materials must be obtained from specialist
retailers.
Select a suitable installation position for the device in the room
to be monitored.
Remove the device from the installation plate.
With the help of the installation plate, draw the four drill holes
on the wall using a pen.
Drill the marked holes (5.5 mm drill, approx. 25-30 mm deep
for concrete surfaces / 2.5 mm drill approx. 20 mm deep for
wood panelling or beams) and insert the dowels.
Tightly screw on the installation plate.
Insert the batteries into the device.
Place the device on the installation plate and turn clockwise to
tighten.
Standard mode
In standard mode the device LED flashes once every 50 seconds.
Function test
ATTENTION: POSSIBLE DAMAGE TO HEARING!
The smoke
alarm emits a very loud and shrill alarm tone which can damage
hearing. When carrying out a function test, remain at least 50 cm
away from the device.
It is recommended that the device be tested weekly to ensure
proper function.
Press and hold the test / learn button for at least 4 seconds, until
the alarm sounds. The alarm tone sounds three times in quick
succession. After a pause of 1.5 seconds the alarm pattern is
repeated twice, until the test / learn button is released. If no
signal or a different signal sounds, the device is defective or the
battery is drained.
If the function test is unsuccessful, replace the device.
Alarm tones
Smoke alarm
Alarm tone sounds six times in succession, each
time for 0.5 seconds with a 0.1 second pause.
The device LED flashes red once every second.
After a pause of 4.5 seconds, the alarm pattern
is repeated.
Heat alarm
Alarm tone sounds for 8.5 seconds successively,
each time for 0.2 seconds with a pause of 0.1
seconds. The device LED flashes red once every
second. After a pause of 4.5 seconds, the alarm
pattern is repeated.
The alarm only ceases to sound when no more smoke particles
are detected by the smoke alarm and the surrounding temperature
falls to 54 °C.
When the alarm tone sounds, check to see whether a fire has
broken out. In the event of a fire, leave the building immediately
and call the fire brigade.
Pairing the smoke and heat alarm with the
BrematicPRO Gateway
The app or BrematicPro PC software is installed and open.
The BrematicPRO Gateway is ready for use.
Keep the device at least 50 cm from the Gateway.
Open the “Settings“ menu.
Select submenu “Rooms,“ then select the room.
Tap the “Add Device“ button.
Select the frequency band “868 MHz“.
Under “New Device“, select “Sensor / Alarm“ and click “Continue“
to confirm your selection.
Wireless Smoke and Heat Alarm 868.3 MHz
