Bremshey Sport RW3, Manual

Page: 23 / 25

▪ Regularly check that all screws and nuts are tight.
▪ If necessary, lubricate the joints.
Lubrication (fig. F)
The equipment must be lubricated regularly, but only if necessary.
▪ If necessary, apply a little lubricant as shown.
Replacing the batteries
The console is equipped with 4 AA batteries at the rear of the console.
1. Remove the cover.
2. Remove the old batteries.
3. Insert the new batteries. Make sure that batteries match the (+) and (-) polarity
markings.
4. Mount the cover.
Defects and malfunctions
Despite continuous quality control, defects and malfunctions caused by individual
parts can occur in the equipment. In most cases, it will be sufficient to replace the
defective part.
1. If the equipment does not function properly, immediately contact the dealer.
2. Provide the model number and the serial number of the equipment to the dealer.
State the nature of the problem, conditions of use and purchase date.
Transport and storage
WARNING
– Carry and move the equipment with at least two persons.
1. Remain standing in front of the equipment on each side and take a sturdy grip at
the handlebars. Lift the front of the equipment so as to lift the rear of the
equipment on the wheels. Move the equipment and carefully put the equipment
down. Place the equipment on a protective base to prevent damage to the floor
surface.
2. Move the equipment carefully over uneven surfaces. Do not move the equipment
upstairs using the wheels, but carry the equipment by the handlebars.
EN
RW3 23