Breitling BENTLEY SUPERSPORTS B55, Manual

Page: 24 / 166

43 42
• Start recording the 1
st
lap by pressing P1 (
L01 RUN
)
• Stop recording the 1 st lap by starting the 2 nd (
L02 RUN
) by pressing P1. The
display then switches to the following lap time.
• Repeat for xx laps (
L
xx
RUN
) up to a maximum of 50 laps.
• Stop the recording (thus the last lap) by pressing P2 (display
STOP
xx alternating
with the 1/100 th of a second on the upper screen and showing the time of the
last lap on the lower screen).
• Pressing P2 again displays the best time corresponding to lap xx on the lower
screen (showing
BEST
xx on the upper screen alternating with the 1/100 th of a
second).
• Pressing on P2 yet once again displays the total time on the lower screen
(showing
TOTAL
on the upper screen alternating with the 1/100
th
of a second).
• Then, successive presses on P2, will display the time of the other laps on the
lower screen (indicating the lap displayed on the upper screen:
LAP
xx). After 10
seconds, the display returns to the last lap.
• A long press on P2 will erase all the times (
RESET
).
If one forgets to turn the timing off, when the total time reaches 99 hours,
59 minutes and 59 seconds, timing ceases. The active lap displays
LAP
xx
OVF
(for overflow). The preceding laps can however still be read.
i) Synchronizing the seconds hand
If the seconds hand does not position itself exactly on 0 in
CHR ADD
mode, proceed
as follows:
• Pull the crown into position 2.
• Press P1 to activate synchronization of the hand (
SyNCHRO
).
• Turn the crown to reposition the hand on 0.
• Press the crown into neutral position 1.
11. LAP TIMER CHRONOGRAPH (
LAP TMR
)
The lap timer chronograph allows several times to be recorded one after the other.
When the recording stops, the next one starts automatically. A maximum of 50
times can be stored and reread when the recording is finished.
When the
LAP TMR
function is selected, the seconds hand positions itself automa-
tically on 0 and becomes the chronograph hand. With each new recording, the
hand goes back to zero and positions itself directly above the second in progress.
It returns to its usual function when the lap timer chronograph function is exited.
a) Recording several laps (
LAP
)
• Select the
LAP TMR
function by turning the crown.