Breitling BENTLEY SUPERSPORTS B55, Manual

Page: 14 / 166

23 22
5. Set the main TIME zone (
SETTIME
) with regard to the difference with the UTC
time (see chapter 6).
6. Press the crown back to neutral position 1.
Depending on the state of the watch prior to being charged, only some, if any,
settings will be required.
N.B.: It is only possible to adjust the minutes in one-minute increments in
UTC
mode.
In
TIME
or
TIME 2
mode, the hours are adjusted depending on the difference with
UTC time and the minutes in 15-minute increments. The seconds on the other hand,
can be adjusted precisely in each of the timezones and will automatically be updated
in the other zones.
It is clear that in the event of a change of summer/winter time or the contrary,
TIME
and/or
TIME 2
timezones must be changed, and not the
UTC
time.
4. ADJUSTING THE TIME BASE OF THE WATCH (
UTC
)
UTC time is the watch’s main time base. The minute on the time base can only
be adjusted in 1-minute increments in this mode. Any modification to UTC time
will automatically have an effect on
TIME
and
TIME 2
(the latter being adjusted
according to the difference with
UTC
). The display of the UTC time is only available
in 24-hour format.
NOTE: To recharge your watch, please use the cable supplied with the trans-
former.
The cable, can, however be used directly on a USB port on a PC/Mac. In this
event, please note that the short-circuit-proof protection of a USB port on PC/
MAC or on a portable computer differs from one device to another.
In order to avoid any possible issues occurring from faulty electric contacts
during recharging, we recommend cleaning the contacts on the watch before
recharging it. Using a soft cloth to do this (without any special cleaning agent)
is adequate.
Please take care not to short-circuit the two contacts on the recharging cable
and in particular, never place the ends of the cable on metallic surfaces.
1. Pull the crown into position 2 (
PULL CROWN
) in order to activate the settings
function.
2. Synchronize (
SyNCHRO
) the hour, minute and seconds hands with the digital
display (see chapter 7.a).
3. Set the exact time on the UTC timezone (
SET UTC
), which constitutes the watch’s
main time base – and not the local time (see chapter 4).
4. Set the date (
SETDATE
) (see chapter 5).