21
Chapter 2: Bed Cabinet assembly.
Stand the Bed Cabinet upright
and against the wall at the
desired location. The Bed
Cabinet should be flat against
the wall. Keep at least a 1/2”
clearance on the sides to allow
for later adjustment.
If your baseboard is larger
than the base notch
provided, please see the
Troubleshooting section on
Page 7.
FIG. 2G
STEP 7
STOP
Using a #2 Phillips screwdriver, verify all cams are locked to the
connecting cam screw.
Are all cam fittings locked?
•
Cam fittings on the Top Nailer, Bottom Nailer, Headboard and Toe
Kick should face the wall and NOT be visible from the front.
•
Cam fittings on the Bed Cabinet Top should face down and
WILL be
visible from below.
If any of these parts are backwards, they must be flipped around.
Are cams facing down or the wall?
If you have any question, contact us (phone:
1-855-466-4781
, email:
or live chat:
https://bredabeds.com
) before proceeding.
*** STOP - SAFETY CHECKLIST ***
The items listed on this page are some of the most common errors during assembly
and can lead to structural failure of the Murphy Bed if not done properly.
DO NOT PROCEED PAST THIS POINT WITHOUT FIRST VERIFYING THE FOLLOWING:
During & after tipping up, do not apply upward pressure to any horizontal panels.
