31
Chapter 7: Final adjustment for the Bed Cabinet and springs.
Chapter 7:
Final adjustment for the
Bed Cabinet and springs.
REQUIRED TOOLS
• Cordless Drill with #2 Phillips
If the bottom of the cabinet can’t be moved side-to-side (e.g. the bed is on carpet), you
can first try sliding the bed on the provided wood shims. If that doesn’t work you
can adjust the top by
first removing the Bed Face Panel (see Chapter 8)
and then
remove the Bed Cabinet Top Nailer from the wall. Prior to doing this, measure how
far and in what direction the bed cabinet needs to shift in order to achieve alignment.
NEVER REMOVE THE SCREWS IN “BED CABINET TOP NAILER”
FROM THE WALL WITHOUT FIRST REMOVING THE BED FACE PANEL.
THE BED CABINET WILL COLLAPSE OTHERWISE.
REQUIRED HARDWARE
• Hardware Card #2
Check that the Bed Face Panel has equal clearance top to
bottom on the left and right sides. If the Bed Cabinet is
leaning to one side, nudge it at the floor level. E.g., if there is
a wider gap along the top-left and bottom-right sides, move
the bottom of the Bed Cabinet to the left to equalize the side
reveals. If there is a wider gap along the bottom-left and top-
right sides, move the bottom to the right.
Once the bed is level and square, you can now attach the “
Bed Cabinet Bottom
Nailer
” in the same fashion as the top was previously attached. Two screws is
sufficient, one on the far left and right stud locations.
STEP 1
If you have any question, contact us (phone:
1-855-466-4781
, email:
or live chat:
https://bredabeds.com
) before doing anything.
If your reveals are even/consistent on each side, top-to-bottom, but you
have a bigger gap on one side or the other, contact us for a remedy.
