background image

MC6S M6x12

MONTERINGSBESKRIVNING

M439-3

SIGLO

SLIDING TABLE TOP

MC6S M6x12 8pcs. 

Used between frame and electrical legs.

1

2

Attach legs to the frame with MC6S M6x12 screws.

MC6S M6x25

Attach felt tray to the legs.

Deep end towards the holes on the top.

Attach feet to the legs with the MC6S M6x25 screws.

MC6S M6x25 8pcs. 

Used between T-foot and elictrical leg.

20170405

Summary of Contents for SIGLO SLIDING TABLE TOP

Page 1: ...sed between frame and electrical legs 1 2 Attach legs to the frame with MC6S M6x12 screws MC6S M6x25 Attach felt tray to the legs Deep end towards the holes on the top Attach feet to the legs with the MC6S M6x25 screws MC6S M6x25 8pcs Used between T foot and elictrical leg 20170405 ...

Page 2: ...Attach the transformer to the table top with the STFX 4 5x45 screw Attach the lock to the tabletop with the STFX 4 0x35 screw See separate installation guide Attach the tabletop to the stand with the STRX 5 0x20 screw STFX 4 0x35 2pcs Used between elictrical lock and table top STRX 5 0x20 8pcs Used between frame and table top STFX 4 5x45 2pcs Used between transformer and table top 20170405 ...

Page 3: ...les and screw them to the table with the STFX 3 5x15 screws Attach the fastening plates with the 6 2x13 screws Attach expanders with the F6S M4x10 The hole at the back hooks to the pinon the fastening plate Apply the plastic heel Screw the locking pin to the locking angel and then screw locking angel to table top K6S M4x10 2pcs Used between locking pin and locking angel F6S M4x10 Systemskruv 6 2x1...

Page 4: ...s Used between felt tray and frame STRX 5 0x17 8pcs Used between felt tray and table top Use the controller to lower the table to it s most bottom position and hold the button until the legs run into end stop It will run approx 3mm out again and then slowly run in again Do not release the down button until the movement has stopped completely Use the controller to raise the table to its highest pos...

Reviews: