29
External Batteries
An external battery may be used to increase the running time. This battery is
essentially the same as the internal battery and will power the ventilator for the same
time, depending on settings and leak
External Battery, part number 0910.
External battery charger part number 0911
These batteries should never be used to run any other type of equipment.
DO NOT attempt to connect any battery other than those supplied by the
manufacturer. Use of any other type of battery could lead to personal injury and
damage to the ventilator.
Instructions For Use
•
Connect the battery to the Nippy Aux Power input.
•
The Power light will illuminate.
•
Switch on the Nippy jnr+. The Ext Batt light will flash and a “Running on battery
power” message will be displayed on the Nippy jnr+ screen. Press the alarm
mute button to hide the message.
•
To disconnect a battery:
Always switch off the ventilator first
. Press the plug
release button on the connector and withdraw the connector.
To Charge a Battery
•
Leave the battery connected to the Nippy jnr+ whilst it is connected to mains
electricity.
Alternatively, charge with the battery charger as follows:-
•
Place the charger on a smooth flat surface.
•
Connect the charger to the battery socket
before switching on the mains
power
.
•
Connect the mains plug to the AC supply and switch on.
•
Leave on charge until the charged / ready indicator lights.
Batteries may produce explosive gases during charging. Always charge away from
sparks or sources of ignition. Do not smoke near a battery whilst charging.
Disconnect the mains power before disconnecting the battery from the charger.
Batteries may be left connected to the charger until required for use.
Safety
Warning!
High voltages exist inside the charger.
Do not remove the cover. Return to B & D Electromedical if a fault occurs.
Do Not expose to water or dust.
Do not cover the charger whilst in use
Ensure that the mains lead is not damaged.
Do not attempt to charge any other type of battery with it.
Battery pack cleaning
To clean, wipe the exterior of the case with a soft cloth moistened with water.
