9
EN
FAN HEATER OSCILLATION MODE
•
Press the button (9) «ПОВОРОТ» on the control
panel (3) or the button (16) «
» on the remote
control (18) to switch the body oscillation mode on,
the symbol «
» will appear in the operation mode
icons row (11). To switch the oscillation mode off,
press the button (9) «ПОВОРОТ» or (16) «
» again,
the symbol
«
» on the control panel (3) will go out.
TIMER SETTING
•
Press the timer on/off button (8) «ТАЙМЕР» on
the control panel (3) or the button (15) «
» on
the remote control (18) and set the requited timer
operation time, the symbol «
» will appear in the
operation mode icons row (11).
• Time setting range is up to 12 hours.
• The timer operation time is indicated with the digital
symbols (12) on the control panel (3).
•
To switch the timer off, consequently press the button
(8) «ТАЙМЕР» or the button (15) «
» until the
digital symbols (12) show the room temperature.
ROOM HEATING TEMPERATURE SETTING
•
Press the buttons (10) «–/+» on the control panel (3)
or the buttons (17) «–/+» on the remote control (18)
to set the required room heating temperature.
• The temperature setting range is from 10 to 35
degrees, the temperature is displayed on the control
panel (3) with digital symbols (12).
•
Switching the fan heater off
•
Switch the fan heater off by pressing the on/off button
(6) «
» on the control panel (3) or the button
(13) « » on the remote control (18).
•
Note:
— after pressing the buttons (6,13), the
heating element will switch off, but the fan will
continue to operate for 30 seconds to cool the
heating element.
•
After the fan stops, switch the power off by setting
the switch (5) to the position «0».
AUTOMATIC EMERGENCY SWITCH-OFF
FUNCTION IF THE OUTGOING AIR IS TOO
HOT
• If the outgoing air temperature exceeds the
acceptable value, the automatic thermal switch will
switch on, and the fan heater will be switched off.
• Set the power switch (5) to the position «0» and
unplug the unit, let the fan heater cool down for
approximately 15-25 minutes (depending on the air
temperature in the room) and only after that you can
switch the unit on again.
•
Make sure that the front (2) and rear grids are not
blocked with foreign objects.
•
Insert the power plug into the mains socket and