BRAYER BR4221, Instruction Manual

Page: 10 / 44

10 EN
Cleaning the filters
The vacuum cleaner operation efficiency depends on the
filters (19 and 24) condition. Clean the filters (19 and 24)
at least 4-5 times a year.
Cleaning the inlet filter (16)
• Switch the vacuum cleaner off by pressing the on/off
button (15) and unplug it.
• Open the dustbag compartment lid (13) by pressing the
lid lock (12).
• Remove the dustbag holder (21) with the dustbag (20)
(pic.3).
• Take a hold of the inlet filter (19) and remove it by
pulling upwards (pic.4).
• Wash the inlet filter (19) with warm water and soft
detergent, rinse and dry the filter (19) thoroughly, then
install the filter (19) back to its place.
Notes: before installing the inlet filter (19), make sure that
it is clean and dry.
• Install the dustbag holder (21) with the installed dustbag
(20 or disposable paper dustbag 27) in place.
• Close the dustbag compartment lid (13) and slightly
press on the lid (13) until the lock (12) clicks.
Cleaning the outlet HEPA filter (24)
• Switch the vacuum cleaner off by pressing the on/off
button (15) and unplug it.
• Remove the outlet filter grid (22) by pressing the lock
(23) and remove the HEPA filter (24).
• Wash the HEPA filter (24) and the grid (22) under a
lukewarm water jet. Do not wash the HEPA filter (24) and
the grid (22) in a dishwashing machine.
• Dry the HEPA filter (24).
• Do not dry the HEPA filter (24) with a hairdryer or similar
appliances.
• Install the HEPA filter (24) back to its place.
• Install the outlet filter grid (22) back to its place.
Note: before installing the HEPA filter (24), make sure that it
is clean and dry.
Vacuum cleaner body
• Clean the vacuum cleaner body with a soft, slightly damp
cloth, and then wipe it dry. Provide that no liquid gets
inside the vacuum cleaner body.
• Do not use solvents or abrasives for cleaning the vacuum
cleaner body and the attachments.
• Do not immerse the vacuum cleaner body, the power cord
and the power plug into water or any other liquids.
OVERHEATING PROTECTION
• If the electric motor gets too hot during the operation, the
overheating protection system will switch on.
• If during the cleaning the vacuum cleaner has switched off,
press the on/off button (15) and unplug the unit.
• Let the vacuum cleaner cool down for 30-40 minutes
and switch it on again. The time of cooling down can be
different from the values above depending on the room
temperature.