BRAYER BR1106, Instruction Manual

Page: 11 / 56

11 EN
3. Make citric acid solution: 2 teaspoons of acid to 1
litre of water and pour the solution into the water
tank (15). Install the tank (15) back to its place.
4. Install the coffee filter (6) into the holder (5) having
preliminary matched the ledge on the filter (6) with
the groove on the holder (5) and turn the filter (6)
counter/clockwise to fix the filter. Do not put ground
coffee into the filter (6).
5. Install the filter holder (5) into the coffee maker. The
holder (5) ledges should match the grooves on the
boiler « », after that turn the filter holder handle
(3) to the right until bumping « ».
6. Place a suitable cup on the grid (2).
7. Insert the power plug into the mains socket.
8. Switch the coffee maker on, setting the power
switch (19) to the «I» position, the indicator (11)
will light up, and the ready indicator (10) will start
flashing.
9. Press the button (9) « » and fill a cup of about
100 ml capacity with water (it is necessary to drain
the water from the boiler and fill the boiler with the
citric acid solution), switch the water supply off by
pressing the button (9) « » again.
10. Wait until the indicator (9) lights up, then switch the
water supply on by pressing the button (9) « »
and fill a cup of about 100 ml capacity, press the
button (9) « » again to switch the water supply
off and pour the liquid out of the cup.
11. After a while repeat the procedure described in
the paragraph 10 and fill the cup of about 100 ml
capacity again.
12. Press the steam supply button (8) « », wait
until the indicator (12) lights up. Put a suitable
bowl under the tip (18) and slightly open the steam
supply by turning the knob (16) « / » to the
position «
». Carefully turn the knob (16) « / » to
the maximal steam release position, release the
steam for about 1 minute, then close the steam by
turning the knob (16) « / » to the position « » and
switch the steam supply off by pressing the button
(8) « ».
13. Switch the coffee maker off by pressing the on/off
button (19) « ». Wait for 10-15 minutes.
14. Perform the steps 10 and 11 at least 3 times.
15. Repeat the cleaning procedure for the steam
release channels described in the paragraph 12.
16. With small intervals, repeat the boiler cleaning
procedure (paragraph 10) until the citric acid
solution dissolves in the tank (15) completely.
17. Switch the coffee maker off by pressing the on/off
button (19) «I».
18. Fill the water tank (15) with clear water until
maximal level and repeat the steps 10, 12 at least 3
times without the 10-15 minute break.
19. Switch the coffee maker off by pressing the on/off
button (19) « ».
Note: to remove the scale you can use special
descaling agents for coffee makers and coffee