21
Controller
1. Release two screws on the right side trim.
2. Release the connectors of controller wire harness (1 black, 1 red, 1 black 9-pin, 1 white
9-pin). Release the copper nut of the throttle cable and pull it out. Put a nail through the hold
to prevent pillar from drawing back.
3. Release four screws on the controller, and cut off the band to remove the controller.
Tools Required: Phillips screwdriver
Time: Allow 10 minutes for procedure
Summary of Contents for EVT- 4000e
Page 1: ...SERVICE MANUAL SERVICE MANUAL EVT 4000e EVT 4000e ...
Page 45: ...43 ...
