USER MANUAL
11
7. Adjust direction of soldering iron
When adjust direction, first unscrew the Nut of corresponding direction,
and then adjust. Unscrew the Nut at the bottom end of Bracket assembly
and turn around or rotate Bracket assembly can all adjust direction of
Soldering Iron. Finally, tighten Nut after adjusting.
Unscrew two Nuts
①
and
②
on top end of Bracket simultaneously and
turn around Handle clamping element can also adjust direction of
Soldering Iron.
NOTE: Please be careful not to break heating element when screw off
black nipple to install connector.
If step on Pedal Switch or press down the red Touch Switch, the
solder wire can’t be sent out automatically, it needs to adjust
feeding pressure―Pressure adjusting screw
⑥
. Refer to
parameter setting.
The Feeder tube can’t be bended overly avoiding the solder wire
block.
When turn on the power Switch, the soldering Iron begin to heat
up (Temperature lamp is light). In order not to be scalded, please
be careful when installing.
Make sure the power voltage in accord with working voltage of
unit.
1.9.
Parameter Setting
1. Feeding Speed setting
Feeding speed is set with digital switch. Press “+” button on the digital
switch and the match digit will increase by one step. Similarly, press “-”
button, and the match digit will decrease by one step.
Summary of Contents for QU376D
Page 18: ...BEDIENUNGSANLEITUNG 15...
