12
Solid green
Appliance is released (switch re-
lease button is pressed) and can
be switched on.
Solid Red
Early warning about overheating.
Motor slows down, step by step,
till shut o
ff
. Let the device cool
down. It is ready for use again
when the pilot light
fl
ashes red.
If the maximum speed decreases under high load
and long running time you can still finish your
preparation, however you should let the appliance
cool down afterwards.
How to Use the Appliance
Smart Speed Switch for
Variable Speeds
One squeeze, all speeds. The more you press, the
higher the speed. The higher the speed, the faster
and finer the blending and chopping results.
One handed operation: the Smart Speed switch (3)
allows you to turn on the appliance and control the
speed with one hand.
Operating your Hand Blender
First use: Remove the transportation lock from the
motor part (4) by pulling it at the red strap.
Switching On (A)
The appliance comes equipped with a safety button
for releasing the Smart Speed switch. To safely turn
it on, follow these points:
•
Press the safety button (2) with your thumb. The
Pilot Light will turn solid green.
•
Immediately press the Smart Speed switch and
adjust to the desired speed. Note: If the Smart
Speed switch is not pressed within 2 seconds,
the appliance cannot be switched on for safety
reasons. The pilot light will flash red. To switch
the appliance on, start again with first step.
•
During operation you do not need to keep the
safety button pressed.
ActiveBlade Shaft (B)
The hand blender is equipped with an ActiveBlade
shaft, which enables the knife extend to the bottom
of the bell. The adjustment is made automatically by
pressure required in blending tasks, especially
suited to mix hard foods e.g raw fruits and
vegetables.
It is also perfectly suited for preparing dips, sauces,
salad dressings, soups, baby food, as well as
drinks, smoothies and milkshakes.
For best results, use the highest speed.
Assembly and Operation
•
Attach the ActiveBlade shaft (6) to the motor part
until it clicks.
•
Place the ActiveBlade shaft into the mixture to be
blended. Then switch the appliance on as
described above.
•
Blend ingredients to the desired consistency
using a gentle up-and-down motion. Depending
on the pressure applied, the ActiveBlade shaft
will depress and blade will extend.
•
After use, unplug the hand blender and press the
release buttons (5) to detach the ActiveBlade
shaft.
Caution
•
Do not let liquids or ingredients overlap the green
line of the blending shaft.
•
If using the appliance to purée hot food in a
saucepan or pot, remove the saucepan or pot
from the heat source and ensure the liquid is not
boiling. Allow hot food to cool slightly to avoid
risk of scalding.
•
Do not let the hand blender sit in a hot pan on the
cooktop when not in use.
•
Do not scratch the ActiveBlade Shaft over the
bottom of pans and pots.
Recipe Example: Mayonnaise
250 g oil (e.g. sunflower oil),
1 egg and 1 extra egg yolk,
1–2 tbsp. vinegar,
Salt and pepper to taste
•
Place all ingredients (at room temperature) into
the beaker in the order as above.
•
Place the hand blender at the bottom of the
beaker. Blend at maximum speed until the oil
starts emulsifying.
•
With the hand blender still running, slowly raise
the shaft to the top of the mixture and back down
to incorporate the rest of the oil.
NOTE: Processing time: approx. 1 minute for
salads and up to 2 minutes for a thicker
mayonnaise (e.g. for dip).
Whisk Accessory (B)
Use the whisk only for whipping cream, beating egg
whites, making sponge cakes and ready-mix
desserts.
Assembly and Operation
•
Attach the whisk (8b) to the gearbox (8a).
•
Align the motor part with the assembled whisk
attachment and push the pieces together until
they click.
5722112034_MQ9045X_INT_S6-116.indd 12
5722112034_MQ9045X_INT_S6-116.indd 12
06.06.16 14:17
06.06.16 14:17