E16521D-Manual_EN_Rev12 2021_JAN_14
Page 17 of 26
Parameter Group P05.xx
Speed Setpoint SP2 and Alarm Output OR2
Parameter No.
Meaning of Parameter
Setting Range of Parameter
Description of Parameters and their Settings
P05.00
Speed setpoint SP2
Range: 00001 .. 99999
Speed setpoint SP2 is set in RPM.
P05.01
Hysteresis bandwidth SP2
Range: 00.1 .. 99.9
The hysteresis is the margin between condition "excess" (>) and "no excess"
(<), defined by its bandwidth. The hysteresis bandwidth is set as a
percentage of the setpoint in steps of 0.1%.
P05.02
Hysteresis position SP2
Range: 0 .. 1
Setting:
0 : hysteresis above SP2 (recommended when monitoring n < SP2)
1 : hysteresis below SP2 (recommended when monitoring n > SP2)
P05.03
De-energized state OR2 at
' n > SP2 ' or ' n < SP2 '
Range: 0 .. 3
Without power supply the relays are de-energized (alarm condition). To
consider safety aspects of the application, this No-Power condition can be
assigned to alarm state n > SP2 or n < SP2 condition.
Setting:
0 : OR2 de-energized at ' n < SP2 '
1 : OR2 de-energized at ' n > SP2 '
2 : OR2 de-energized and latched at ' n < SP2 '
3 : OR2 de-energized and latched at ' n > SP2 '
P05.04
Starter effective for SP2
Range: 0 .. 1
The starter function may be effective for each setpoint individually. Thereby
it is possible, for instance, to disable a low-speed alarm during the starter
phase, whereas a high-speed alarm remains active all the time.
Setting:
0 : starter not effective for setpoint SP2
1 : starter effective for setpoint SP2
P05.05
OR2 state at starter condition
Range: 0 .. 1
At starter condition, the relay may be forced to state energized or
de-energized (if starter function is effective for the alarm).
Setting:
0 : OR2 de-energized
1 : OR2 energized
P05.06
OR2 in forced de-energized
state at
sensor fault condition
Range: 0 .. 2
At sensor fault, OR2 may be forced to de-energized state.
Setting:
0 : no forced state, state acc. to measured speed
1 : OR2 in de-energized state as if n > SP2 (if P05.03 is 1 or 3)
2 : OR2 in de-energized state as if n < SP2 (if P05.03 is 0 or 2)
