64
How to use the drying programmes
On/Off
Programme
switch
Anti-crease exclusion
Start
Important
: remember that if there’s a power failure or if the door is opened during a
drying cycle, the appliance will automatically restart once the initial conditions are
restored. On completion of the drying cycle, a cool air ventilation phase will start
automatically. After this, four acoustic signals will tell you the cycle has ended. If you
haven’t selected the Anti-crease exclusion option, the 60 minute anti-crease phase
will now start. During this stage the laundry may be taken out at any time.
Led
Description
Programming a drying cycle:
• press the “
ON/OFF
” button (acoustic signal);
• if you want a delayed start, choose one of the four programmed
delay times (1 to 4) before setting the programme and wait 3
seconds. An acoustic signal will tell you when your choice has been
accepted;
• now choose a programme by turning the switch to the desired
setting;
• the “
Anti-crease exclusion
” option may be chosen at this point;
• press the “
Start
” button *, an acoustic signal will tell you drying has
begun.
* the “Start” button doesn’t stay pressed down.
Adding or removing an item during a drying cycle:
• open the door;
• add or remove laundry *;
• press the “
Start
” button (acoustic signal).
* be careful not to scald yourself.
Modifying a drying cycle in progress:
• set the pointer on the switch to “Stop” and wait for the acoustic
signal;
• choose another programme;
• restart the drying cycle (see above).
Cancelling a drying cycle in progress:
• press the “ON/OFF” button at any time during drying.
Maintaining your dryer’s performance:
• clean the filter after each cycle (the “Filter” led lights up at the end
of the cycle);
• empty the tank after each cycle;
• clean the condenser once a month.
ON flashes rapidly
then stays lit
ON flashes rapidly
then stays lit
ON flashes
ON flashes
ON flashes
ON flashes
Tank filter
full
