Brandt BPI6413BM, Manual For Installation And Use

Page: 17 / 32

17
•
Adjust the hob connections : these
are located underneath the knobs
(Fig. 04).
— Proceed one tap at a time.
— Remove the knobs and the gaskets by
pulling them up.
- Natural gas passage
-
Using a small flat-head screwdriver, screw
in the brass burner power screws (yellow)
all the way, moving in a clockwise direction
(Fig. 05).
-
Replace the gaskets and the knobs,
paying careful attention to their direction
and ensuring that the knobs are pushed in
all the way.
- Switching from butane/propane to
natural gas
-
Unscrew the brass (yellow) burner power
screws (Fig. 05), using a small flat-head
screwdriver,
turn twice
counterclockwise.
-
Replace the knob.
-
Light the burner in maximum heat mode,
then turn down to reduced heat mode.
-
Remove the knob again, then turn the
burner power screw clockwise until it
reaches the lowest possible setting that
does not extinguish the flame.
-
Replace the gasket and knob.
-
Make several attempts to shift from the
maximum flow rate to the minimum: the
flame should not go out ; if it does,
unscrew the burner power screw so as to
obtain good flame retention during these
position switches.
-
Reposition the burner heads, burner
covers and pan supports on the hob.
1/ INSTALLING YOUR APPLIANCE EN
Knob
Sealing
ring
Tap
Fig. 04
Fig. 05
Tap axis
Burner power
adjustment screw