Brandt BPI6413BM, Manual For Installation And Use

Page: 15 / 32

15
•
Gas supplied by tank or
cylinder (butane/propane)
For your safety, you must choose from the
three following connection options:
— Connection with a rigid pipe made
from copper and with screw-on mechanical
connectors (G1/2 gas standard mark). Make
the connection directly to the end of the
elbow fitted on the appliance.
— Connection with a wavy metal hose
(stainless steel) with screw-on mechanical
connectors (compliant with the NF D 36-125
standard) whose service life is unlimited
( Fig. 01).
—
Connection with a reinforced rubber
hose with screw-on mechanical
connectors (compliant with the NF D 36-112
standard) whose service life is 10 years
(Fig. 02).
A
B
Sealing washer (not provided)
Adaptor (not provided)
Clamp (not provided)
C
Warning
All soft pipes and hoses whose
service life is limited must have a
maximum length of two meters and
must be accessible along their entire
length. They must be replaced before
the end of their service life (marked
on the pipe). Regardless of the means
of connection chosen, ensure that the
connection is leaktight, after
installation, with soapy water.
In France, you must use a hose or a
pipe bearing the stamp NF Gaz
In an existing system, a soft pipe fitted with
clamps (compliant with the XP D 36-110
standard) whose service life is five years
may be used. It is necessary in this case to
use an adaptor without forgetting to fit a
sealing washer between the adaptor and
the hob’s elbow (Fig. 03).
Tip
You can obtain the adaptor and the
sealing washer from your After-Sales Service
Department.
Warning
Screw on the adaptor with a
torque not exceeding 25 N.m.
;
;
@
@
;
;
Q
Q
Fig. 01
Fig. 02 Fig. 03
A
B
C
1/ INSTALLING YOUR APPLIANCE EN