Brandt BFK734YSS, Instruction Manual

Page: 25 / 54

•
After everything is dry place appliance
back into service.
1.0 Electrical connection
When the appliance is plugged in, all LED
indicator lights will flash once.
Then the appliance will resume the mode
previously set before the electrical outage.
2.0 Temperature Setting
¾ Setting: Press “SET” button, enter the
temperature setting mode. The temperature
indicator bar of temperature goes up a scale
by each press. This setting runs in cycles.
Temperature can run from Scale MIN to
Scale MAX. Scale MAX is the coldest. The
temperature is automatically set in 5 seconds
after last press.
¾ Super Freezing
9
Press “SET” button consecutively to
enter “SUPER” freezing mode from
Scale MAX, the indicator bar on the
left hereby will turn dark whereas the
indicator light of “SUPER” turns on.
This mode is automatically set in 5
seconds after last press.
9
The compressor keeps working in
“SUPER” freezing mode.
9
If the “SUPER” mode keeps running
for 52 hours and not stopped
manually, the system will
automatically cut out this mode, with
the temperature back at Scale 5.
2.1 Power On & Power Off
If the appliance is working, press “ON/OFF”
for 3 seconds to turn off.
If the appliance is off, press “ON/OFF” for 3
seconds to turn on.
3.0 Indicator Lights
¾
Temperature Indicator Light (Bright
Blue): To adjust the temperature from
Scale MIN to Scale MAX. MAX is the
coldest.
¾
Super Freezer Indicator Light (Bright
Blue): Light on = in “SUIPER” mode; light
out = exit “SUPER” mode.
9
Running Indicator Light (Bright Green): Light
on = compressor in work; light off =
compressor stops.
9 30 minutes after the last operation, the
indicator light will be on in half luminance.
4.0 Resumption Function
The appliance will automatically resume the
mode previously set before the electrical
outage.
5.0 Temperature Sensor Fault Alarm
When there is a disconnection or short out of
the temperature sensor, as a fault alarm, the
temperature indicator bar will flash from left
to right every 0.5 second.
Defrosting of the freezer
•
The freezer, however, will become
progressively covered with frost. This
should be removed.
•
Never use sharp metal tools to scrape off
frost from the evaporator as you could
damage it.
•
However, when the ice becomes very
thick on the inner liner, complete
defrosting should be carried out as
fellows:
Unplug the unit. Remove the drain plug
from the inside of the freezer. Defrosting
usually takes a few hours. To defrost
faster keep the freezer door open.
For draining, place a tray beneath the
outer drain plug. Pull out the drain dial.
11