8
English
4 Initial use
Take the device out of the package and remove all the packaging material. Place
the lamp on a flat and even surface, so that it does not fall over. Remove the bat
-
tery safeguard on the rear of the lamp by turning the battery compartment anti
-
clockwise and removing the plastic washer between the battery and the contact.
Then close the battery compartment properly again.
Then insert the supplied DC coaxial power connector into a properly installed pow
-
er socket and connect it to the lamp in order to start using it.
You can switch the lamp on or off by touching "ON / OFF".
Touch the "Mode" button to select one of the three light modes (natural, white
and yellow light). To adjust the brightness of the lamp, touch the "increase" or "de
-
crease" button (with the lamp switched on) until you get the desired brightness.
5 Display functions
First, set the current time and the current date. To do this, press the "SET" button
on the back of the lamp. The time starts flashing. Set the desired time using
the "UP" and "DOWN" buttons. Confirm your entry using the "SET" button. The
setting sequence is as follows: Hour -> Minutes -> Year -> Month -> Day.
Press the "UP" button to change between the 12-hour and 24-hour display.
Press the "DOWN" button to change between °C and °F.
Alarm function:
Press the "MODE" button to display the currently set alarm. Press the "SET" but
-
ton once the display shows the alarm time. Now you can enter the desired alarm
time. Confirm the settings by pressing the "SET" button. The setting sequence
here is as follows: Hours -> Minutes -> Snooze time -> Alarm.
Press any button on the rear of the device to stop the alarm and to turn off the
alarm completely.
Press the "MODE" button to turn on the alarm, so that you are in the alarm
mode. You can turn the alarm on or off using the "UP" and "DOWN" button. The
