INSTALLATION INSTRUCTIONS
3 of 6
GS
Section 2: Camera Installation
5.
Remove the sheet metal cover from inside of the bed on the tailgate by removing the Torx bolts
holding it on.
6.
Remove the tailgate handle by loosening two nuts with a 10mm socket.
7.
Route camera harness through handle opening in tailgate to the hole in the bottom of the tailgate.
8.
Reconnect to latch rods onto the handle.
9.
Install supplied tailgate handle camera into tailgate by tightening two nuts with 10mm socket.
10.
Pass the connector end of the tailgate handle camera through the 1-inch opening in the pickup bed.
11.
Reattached the tailgate to the bed of the truck if you had to remove it for installation of the camera
harness.
12.
Reinstall the metal cover back on the tailgate with the Torx bolts that were just removed.
