INSTALLATION INSTRUCTIONS
AVMS-3604.doc
Page 3 of 9
8.
With the sticker still in place, drill the (2)
mounting screw holes with a 1/16 drill bit.
(
Do not go all the way though
.)
9.
The side cameras, brackets and pods are
labeled for right-RH and left-LH. Make sure
to assemble them correctly. Use caution not
to loss the tiny screws to mount the
cameras to the brackets and the brackets to
the pods.
10.
Using the LH camera assembly, attach the
foam gasket to the bottom side of the pod,
lining up the notch in the foam with the
bump on the pod.
11.
Remove the tape from the foam gasket and
mount the camera pod to the mirror. Use
the self tapping screws provided to mount
the pods to the underside of the mirror. (
Do
not over tighten the screws, it may strip out
the plastic.)
12.
Route the camera cable though the mirror
and out of the mounting side of the mirror.
Make sure not to block any movement of
the mirror glass or folding.
13.
Route the cable in the door and remount
the mirror to the vehicle.
14.
You will next pin the camera cable wires
into the provided connecter. Inset the pins
into the connecter until they make a “snap”
sound. Use the left side camera harness to
match up where the pin locations are.
(See
Diagram chart
1a
. at end of instructions for
all camera pin connections.)
