DIGIMIC
DCen MkII
Operating Instructions
11
BRÄHLER Systems GmbH
Auf der Alten Burg 6
53639 Königswinter
Germany
T +49224 4 8414-4
www.braehler-systems.com
05.0055 220223 V1.0 BRÄHLER Systems is constantly improving its products and therefore reserves the right to make technical changes without notice
LINE-IN
LINE-IN socket (Phoenix terminal) for feeding external signals for decentralized sound
reinforcement via the integrated loudspeakers of the microphone consoles, as well as the
original signal for the interpreters. If the signal is fed in via a mixing console and is to
come through the integrated loudspeakers, the signal must be fed back from the mixing
console. This is done via the LINE-IN socket, line level, transformer balanced.
LINE-OUT
A sum signal of all switched-on delegate units can be taken from the LINE-OUT socket
(Phoenix terminal). In the audio matrix the signal routing for this output can be changed if
required, line level, transformer balanced.
Line output jacks Out1- Out4
Audio signals are transmitted to external devices via four LINE
outputs (Phoenix terminal). For example, an external mixing
console can be connected to these jacks to perform sound
recordings or to route signals to a PA system. In the audio matrix,
the signal routing for these outputs can be changed if required.
Reset
Press and hold this button when powering on the DCen MkII until the DCen has finished
booting. This will reset the network settings to DHCP. To reset all settings to factory defaults,
use the DCenConfig tool.
If you press the button while the DCen is running, this can be displayed in
the DCenConfig tool. This helps you to identify a specific DCen.
LAN
The DCen MkII can be connected to your network via the LAN socket. This gives you the
ability to control the unit and all connected units via software. Never plug a cable from
DIGIMIC microphone consoles into this LAN jack.