10
11
Entering Your Program–7 DAY, Residential Mode
(continued)
Individual Days –
allows you to program each day of the week individually to give you the greatest schedule
flexibility. Often used to fine tune programming after initial programming.
IMPORTANT NOTE!
When in Whole Week programming, the thermostat will check if all of the days of that
group have the same program set point times and temperatures. If so, the set point time and temperature of the
individual set point will be displayed.
Otherwise, the individual set point time and temperature will be blanked. The user is allowed to change the daily
programs for this set point time and temperature by pressing the or button. This will reset all the daily
programs of the group for that specific individual set point time and temperature to the startup default for that
set point. Continued pressing of the or button by the user will change set point time and temperature
settings as desired.
Programming Instructions–7 DAY, Residential Mode
1.
Press the
PROG
button to enter the Program setting mode.
Press the
SYSTEM
button to select
HEAT
(not
AUTO HEAT)
to set
heating times and temperatures.
MORN
set point of the “Whole
Week” will be displayed. The display will show
M, TU, W, TH,
F, SA, SU
to indicate the whole week is being programmed.
The hour portion of the set point time and the
AM/PM
indicator
will be flashing.
2
PROGRAMMING
USER SETTINGS
cont.
2
PROGRAMMING
USER SETTINGS
cont.
2.5
Setting Your Energy Saving Programs
(continued)
• Independent heating and cooling temperatures are available in auto changeover mode. Independent program times and
fan settings for heating and cooling are NOT available in auto changeover mode.
• When you place the system in the
HEAT
or
COOL
modes of operation, an appropriate indicator will appear in the LCD
display when the system is running.
• When you place the system in the
OFF
mode the display will indicate
OFF
.
NOTE:
If the
PROG
button is pressed while
AUTO
is selected, the
thermostat will switch from the
AUTO
mode to the mode currently in
the display.
NOTE:
If Auto Changeover is enabled in the Installer Options, and a
setting is made in either heating or cooling which violates how far apart
heat and cool are (the dead band), the opposite mode will adjust up or
down automatically to maintain the dead band spacing (see section 3.2).
NOTE:
If a Heat Limit was set in the Installer Options, the heating set
point cannot exceed that limit. If a Cool Limit was set in the Installer
Options, the cooling set point cannot be less than that limit.
Entering Your Program–7 DAY, Residential Mode
The 7 Day mode has separate Whole Week or Individual Day programming to allow you to change the daily set
point times and temperatures to meet your individual schedule needs. The Whole Week programming can be used
to set the main portion of your schedule, allowing you to later modify specific days of the week as required using
the Individual Day programming capabilities.
Whole Week –
allows you to program all seven days (M, TU, W, TH, F, SA, SU will show in display) at the same time.
Then you can use the individual day programming to fine tune your program for the few set point times or
temperatures that you may wish to change.
NOTE:
If Auto Changeover is enabled in the installer options, the heating and cooling programs share time and
fan settings. If a setting is made in either heating or cooling which violates the dead band, the opposite mode will
adjust up or down automatically to maintain the dead band spacing (see section 3.2).
